Any easy way to turn off nag message before I upgrade firmware?
 

Any easy way to turn off nag message before I upgrade firmware?  

  RSS
jsw
 jsw
(@jsw)
Reputable Member

This afternoon I clicked on the 'load updated parameters' (or something similar) message when I ran PrusaSlicer and now whenever I go to do a print it displays this 'Updated firmware available, please upgrade' message at the start of each print and does appear to delay the print start.

I don't want to flash new firmware until I finish with some important prints.

Is there any convenient way of turning off this nag message, at least temporarily?

Thanks.

Posted : 27/05/2020 8:30 am
peter.k42
(@peter-k42)
Estimable Member

Look in the Start Gcode tab under Printer Settings.

Comment the first line, or the one that has a comment about current firmware.  Boom!  No nag message.

This post was modified 2 months ago by peter.k42
Posted : 27/05/2020 3:02 pm
jsw
 jsw
(@jsw)
Reputable Member

Thanks.

I assume it's this line:

M115 U3.9.0 ; tell printer latest fw version

I won't be able to try it for a while because the current print has 6 more hours to run, but we'll see if it works after that.

Posted : 27/05/2020 3:19 pm
peter.k42 liked
Lichtjaeger
(@lichtjaeger)
Prominent Member

Or deactivate Firmware checks in the hardware settings of your printer.

Posted : 27/05/2020 3:19 pm
Share:

Please Login or Register