Notifications
Clear all

Adjustments for retraction  

  RSS
Vicent
(@vicent)
Active Member
Adjustments for retraction

Good morning everyone

In the Prusaslicer software, there are two possible settings for retraction.

1.- In Printer Settings

2.- In the Filament Configuration

Which of the two settings is the one that prevails for printing?

Regards

Vicent

Publié : 04/04/2021 9:11 am
Karkovski
(@karkovski)
Membre Moderator
RE: Adjustments for retraction

Hello Vincent,

the filament settings override printer settings.

Publié : 04/04/2021 9:39 am
Vicent
(@vicent)
Active Member
Topic starter answered:
RE: Adjustments for retraction

It was what was to be expected, but I was in doubt.

Thanks for confirming it.

Regards

Publié : 04/04/2021 10:33 am
Partager :