Notifications
Clear all

3.9.3 Firmware Update: No SuperPINDA Option?  

  RSS
Extra Fox
(@extra-fox)
Reputable Member
3.9.3 Firmware Update: No SuperPINDA Option?

I just performed the 3.9.3 update and I'm not seeing the option to turn the SuperPINDA on or off in the "HW Setup" category. I've checked the version of the firmware on the printer and it shows 3.9.3-4117, which I believe should have this option.

And yes, I do have the SuperPINDA installed on my printer.

Full Disclosure: I'm using the BondTech branch of the firmware, but my understanding was they only monkey with the settings for the extruder, hot end, and temperature probe. If they mess with more, I'd be happy to bring this up with them.

Best Answer by Extra Fox:

You know what, I read the release notes incorrectly on GitHub. I just went back and it said the MK3's do this automatically and it was only something necessary for the MK2 printers. My bad, please disregard. 😌 

Aaron

Posted : 15/01/2021 5:31 pm
Dp67 liked
cwbullet
(@cwbullet)
Member
RE: 3.9.3 Firmware Update: No SuperPINDA Option?

I am using the same and it is printing fine.  Why are you concerned?  I do not think they're such a choice on the standard Prusa firmware.  I will find out today as I install it on my other printers.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 15/01/2021 6:47 pm
Extra Fox
(@extra-fox)
Reputable Member
Topic starter answered:
RE: 3.9.3 Firmware Update: No SuperPINDA Option?

You know what, I read the release notes incorrectly on GitHub. I just went back and it said the MK3's do this automatically and it was only something necessary for the MK2 printers. My bad, please disregard. 😌 

Aaron

Posted : 15/01/2021 6:52 pm
Share: