Notifications
Clear all

What settings could be adjusted to fix this?  

  RSS
ldv2001
(@ldv2001)
New Member
What settings could be adjusted to fix this?

Hi!

 

I recently received my new E3D NozzleX 0.8.

Since PrusaSlicer do not come with presets for 0.8 nozzle, i added the profiles from Bob's Project Notebook. The 0.4 profiles works great with both PLA and PETG. The 0.8 profiles work great with PLA. Then I received a spool of Prusament Galaxy Black PETG. Printing a flower pot with it resulted in the seam in the image.

 

Whats settings could be relevant to look at to fix this seam?

 

 

Posted : 09/06/2020 11:06 am
ldv2001
(@ldv2001)
New Member
Topic starter answered:
RE: What settings could be adjusted to fix this?

Also, I'm using PrusaSlicer 2.3.0 and Firmware 3.9.0 for my Prusa MK3S.

Posted : 09/06/2020 12:19 pm
jsw
 jsw
(@jsw)
Famed Member
RE: What settings could be adjusted to fix this?

I'm not the expert on settings, but when I have something that prints with artifacts which definitely should not be there, I will try re-slicing the project with cura instead of prusaslicer.   Sometimes (not always) the cura-sliced print will be better.  In general, however, I've found that prusaslicer produces nicer prints than cura, with the top layer having fewer artifacts with prusaslicer, very consistently.

Posted : 09/06/2020 12:49 pm
Share: