Notifications
Clear all

Warping in specific spots on the bed  

  RSS
Larry
(@larry)
Eminent Member
Warping in specific spots on the bed

I'm having a consistent issue where PLA prints warp only near the middle of the bed.
If I move my print to the sides, things work better. Obviously still a problem for larger things.

I'm assuming there is an air-flow issue and I'm creating an enclosure and downloading the new extruder parts.
So I'm not chasing my tail...wanted to see if anyone else has any thoughts around this issue.
TIA!

Posted : 12/09/2018 10:36 pm
Kai
 Kai
(@kai-2)
Famed Member
Re: Warping in specific spots on the bed

You write that it is always at the same area on the printbed.
Did you already clean the bed in this specific area?

Wer freundlich fragt bekommt auch eine freundliche Antwort.
nec aspera terrent

Posted : 13/09/2018 1:44 pm
cwbullet
(@cwbullet)
Member
Re: Warping in specific spots on the bed

Similar experience/. Cleaning did not help. In particular, Orange IC3D PLA is terrible

--------------------
Chuck H
3D Printer Review Blog

Posted : 13/09/2018 3:19 pm
Share: