Notifications
Clear all

Print Bed Sliding  

  RSS
tcfonehome
(@tcfonehome)
New Member
Print Bed Sliding

I've been having an issue where my print print bed slides off of the printer 10 hours into a 12 hour print job. It has done this twice so far trying to print the same model. Crash detection was never triggered and the nozzle didn't clog. Do you have ideas on what the problem might be or ideas on how this can be resolved? i3Mk3s Prusament PC Blend Filament using default prusa PC blend settings with .3mm layers.

Posted : 03/07/2020 2:37 am
tcfonehome
(@tcfonehome)
New Member
Topic starter answered:
RE: Print Bed Sliding

I think I figured out the problem. My print was warping near the end of the print job, however since I had such good bed adhesion instead of lifting my print off of the build plate, my print lifted my build plate off along with it. This allowed my bed and print to partially slide off of the printer.

Posted : 03/07/2020 4:17 pm
Share: