Notifications
Clear all

Minitemp Error  

  RSS
Lodi
 Lodi
(@lodi)
New Member
Minitemp Error

One of the wires to the heat element on my came off and caused a small short (spark).  I replaced the heat element and I am getting a minitemp error.  I measured the resistance on the new heat element and it checks out.  I am hoping I didn’t damage the main board.  Is there any way to check it?  Any other thoughts as to what might be causing the error?  Thanks!

Posted : 11/04/2021 7:31 pm
Geekware
(@geekware)
Eminent Member
RE: Minitemp Error

A few of us had this problem. Lesson learned.

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/mintemp-error-after-possibly-shorting-board/

Posted : 11/04/2021 7:41 pm
Lodi
 Lodi
(@lodi)
New Member
Topic starter answered:
RE: Minitemp Error

Thank you!

Posted : 12/04/2021 3:25 pm
Share: