Notifications
Clear all

Live Z  

  RSS
SnowEagle
(@snoweagle)
Eminent Member
Live Z

After upgrading from Mk3s to Mk3s+ my live Z Smooth sheet went from 0.710 to 1.133.  Should I be concerned? What is yours?

Posted : 27/01/2021 11:49 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Live Z

No.  Especially no concern if you installed the SuperPinda.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 28/01/2021 11:42 am
SnowEagle
(@snoweagle)
Eminent Member
Topic starter answered:
RE: Live Z

@cwbullet

Okay, Thanks!

Posted : 28/01/2021 12:14 pm
SnowEagle
(@snoweagle)
Eminent Member
Topic starter answered:
RE: Live Z

At what point does this distance become excessive?

Posted : 28/01/2021 1:37 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Live Z

-2.000.  That is when you can’t adjust it any more.  If it bothers you, lower your Pinda one click.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 28/01/2021 1:41 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Live Z
Posted by: @cwbullet

-2.000.  That is when you can’t adjust it any more.  If it bothers you, lower your Pinda one click.  

And redo you live Z

--------------------
Chuck H
3D Printer Review Blog...
Posted : 28/01/2021 1:41 pm
SnowEagle
(@snoweagle)
Eminent Member
Topic starter answered:
RE: Live Z

@cwbullet

Okay, thanks again! I was just concerned because you see so many varying heights and I was wondering about a range of settings to look for.

Posted : 28/01/2021 1:53 pm
Share: