Notifications
Clear all

Filament breaking / jamming between gear and ptfe tube  

  RSS
Pallo
(@pallo)
New Member
Filament breaking / jamming between gear and ptfe tube

This is partially disassembled to remove hotend and show location.

This is Prusa PLA filament that came with printer.  No mods.  I assembled this a few days ago.  Calibrated fine and made several successful prints.  I started a print immediately after a successful print and returned to find ZERO filament on the board or anywhere else.

PTFE tube is blocked by bunched up filament.

Posted : 25/01/2021 4:49 am
Share: