Notifications
Clear all

Failing supports with PRUSAMENT Vanilla White  

  RSS
The Grue
(@the-grue)
Eminent Member
Failing supports with PRUSAMENT Vanilla White

Hello, 

I've had some trouble with clogging reccently, but that seems to be resolved now (still keeping my fingers crossed). But now, I see failing supports on the 36hours print which is running right now:

 

On the picture, you can see how the rightmost support starts fine, but as it gets higher, it starts to oscillate and gets very weak. I paused the print, stabelized it with some hot glue and a piece of wood, now it's fine again.

I didn't have that trouble with galaxy black or silver filament from Prusa...

How can I avoid such failling supports in future prints (besides avoiding Vanilla White)?

 

This topic was modified 4 years ago by The Grue
Posted : 28/09/2020 1:42 pm
cwbullet
(@cwbullet)
Member
RE: Failing supports with PRUSAMENT Vanilla White

Defintely poor extrusion.  I am not sure why it just this support.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 29/09/2020 12:44 am
Share: