Notifications
Clear all

Extruder REassembly  

  RSS
Pathogen
(@pathogen)
Estimable Member
Extruder REassembly

My extruder would not heat up beyond 140 degrees after REassembly due to me not doing it correctly (specifically I had the heatsink flush against the heatblock, which sucked out the heat too quickly). Prusa support did not catch this and assumed the heat cartridge was buggered and sent me a new one.

I post this in the hopes that the support team can avoid this in the future. I have a bonus heat cartridge now which is great but it was not required.

TAG: PREHEAT ERROR

Posted : 23/10/2018 5:02 pm
Share: