Notifications
Clear all

Extruder and fans stop, but print continues to end  

  RSS
Zeke
 Zeke
(@zeke)
Active Member
Extruder and fans stop, but print continues to end

The last 3 times I've tried to print a large (5+ hrs) I've come back to the printer to find a partial print, but the extruder is parked & the screen shows no errors.
Today I was able to keep a better eye on the print and the last time I checked it, the extruder and fans were not operating, but the printer was continuing the X Y & Z moves as if nothing was wrong. The extruder motor was pretty hot, but there wasn't any kind of jams or clogs.
After I stopped the print, I noticed that the bed was cold, so I guess the bed heater had also stopped working. I didn't think to check the hotend temp.
Anyone have any idea where I should start in troubleshooting this?
The EINSY board?

Posted : 25/08/2018 3:48 am
LaPointe
(@lapointe)
Moderator
Re: Extruder and fans stop, but print continues to end

Hi!

First thing to check for me since it's the easier: which firmware do you have? If not the last, I would suggest a factory reset, then FW upgrade, and then another factory reset.

Posted : 25/08/2018 9:41 am
Share: