any long term issues with not having the filament sensor on automatic?
 
Notifications
Clear all

any long term issues with not having the filament sensor on automatic?  

  RSS
Charles Strait
(@charles-strait)
Active Member
any long term issues with not having the filament sensor on automatic?

I just had my first really bad nozzle and tube plug due to using some new cheap filament.  After removing and cleaning my nozzle and installing a new Plastic tube, I started having errors with my filament sensor.  I am guessing I tightened the screws too tight so something was impeding the sensor from working properly.  My quick fix was to just turn off the automatic function and everything seems to be working well.  Is there any drawbacks to turning off the automatic settings on the sensor?

Opublikowany : 02/08/2020 9:33 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: any long term issues with not having the filament sensor on automatic?

apart from not getting the run out feature and auto loading, no... 

I would try printing a filament sensor spacer

https://www.thingiverse.com/thing:4006603

https://www.thingiverse.com/thing:4079248

 unscrewing the top of the extruder, unscrew the filament sensor, 
Have a peep inside to see if the lever is moving freely

if it is, try fitting a spacer under the sensor PCB... and fasten it up again

I fitted an LED to my sensor, to get immediate status notification

here is the  extruder with the top cap removed to show the installation of a 5volt LED

 regards Joan

 

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Opublikowany : 03/08/2020 12:58 am
Charles Strait
(@charles-strait)
Active Member
Topic starter answered:
RE: any long term issues with not having the filament sensor on automatic?

@joantabb

Thank You Joan.  I will try that.

Opublikowany : 09/08/2020 4:40 pm
Share: