Notifications
Clear all

Z calibration width Ok (1.1 mm) but square test is KO  

  RSS
Vincnet Diallo-Nort
(@vincnet-diallo-nort)
New Member
Z calibration width Ok (1.1 mm) but square test is KO

Hello, I watch this video on the calibration of Z-axis and the recommended width is 1.1 mm so i set the high to obtain this width,but the little square at the end doesn't look good. Any idea what I missed ?
Bellow a picture of the square ( from what I understand it means i am too low )

Regards

 

Vincent Diallo-Nort

Best Answer by cwbullet:

That might be a bit too low.  I usually raise my live Z or Z offset by 0.025 and try printing again.  You can adjust up or down from there till the square is perfect.  Remember minus is down and Positive is up.    

Posted : 29/07/2021 8:19 am
cwbullet
(@cwbullet)
Member
Offset

That might be a bit too low.  I usually raise my live Z or Z offset by 0.025 and try printing again.  You can adjust up or down from there till the square is perfect.  Remember minus is down and Positive is up.    

--------------------
Chuck H
3D Printer Review Blog

Posted : 29/07/2021 9:38 am
Vincnet Diallo-Nort
(@vincnet-diallo-nort)
New Member
Topic starter answered:
Thanks

Thanks

Posted : 29/07/2021 12:13 pm
Share: