Z axis being weird during calabration
I just built my PRUSA i3 MK3s+ kit and when I booted it up for the first time it started the wizard as expected but when it got to calibrating the Z axis it went up just a few inches, not at all close to getting to the top (video here: ) as I gather it is supposed to do. It doesn't say it failed it just says its good and continues on alright until the "calibrate XYZ" step where it fails before the first point and the screen says "check axis and reboot to try again"
Best Answer by Baklin:
Not sure if it fixes it. But it looks like you have the black nuts for de z-axis up side down. Hard to tell in de video.
RE: Z axis being weird during calabration
This is a video of the XYZ calibration failing. ( ) I moved the Z up to the top myself.
RE: Z axis being weird during calabration
Not sure if it fixes it. But it looks like you have the black nuts for de z-axis up side down. Hard to tell in de video.
RE: Z axis being weird during calabration
@baklin
that's what I noticed a few hours after posting. I thought I marked it as solved?