Notifications
Clear all

Y Axis Pattern Layer Shifting  

  RSS
lange35
(@lange35)
New Member
Y Axis Pattern Layer Shifting

All of my parts are coming out with layer shifts in the y-direction, but rather than a constant shift that I've seen on forums that would indicate that the printer axes aren't square, mine are coming out with an almost sinusoidal pattern where each layer shifts in a different direction. Does anyone know what could cause this?

Posted : 11/09/2021 10:25 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Starting

Check your grub screw on the y axis gear.  One of them must be tight against the flat side of the shaft.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 13/09/2021 9:52 am
Share: