Notifications
Clear all

[Solved] Weird first layer  

  RSS
Q
 Q
(@q)
Active Member
Weird first layer

Hi all,

 

Probably one of these noobs issues, but... I noticed recently that the first layer is odd - uneven. When I calibrate it, I got a very different lever on the top right corner, seems like the nozzle is too low, but works great for the rest. See the picture:

This is while trying to calibrate with a .6 nozzle. 

 

I don't think I had this issue initially, but I'm not sure when it came up. I tried tightening the top right screw on the heat bed and then re-running a full calibration, no luck.

 

Could that be an issue with the bed sheet? Any other idea?

 

Thanks a bunch!

 

- Quentin

Posted : 05/09/2021 7:02 pm
Q
 Q
(@q)
Active Member
Topic starter answered:
Nevermind...

It seems to have been caused by a very small spec of debris between the heat bed and the bed sheet 😱 

Posted : 05/09/2021 9:32 pm
Xanthe
(@xanthe)
Trusted Member
Been there...

Done that! 🤣 

Posted : 06/09/2021 2:25 pm
Share: