Notifications
Clear all

Watch out: Heatbed screw head tolerence i3 MK3S  

  RSS
Steve C
(@steve-c)
Active Member
Watch out: Heatbed screw head tolerence i3 MK3S

Just a quick bit of feedback ... on assembling the heatbed, I noticed that not all of the screws went down properly into the recess - this appears to be a tolerencing issue.  For me, I dug into the spares bag, and found two screws there which were OK.  Just thought I'd make any assemblees aware.

Regards, Steve

 

Posted : 29/07/2020 8:29 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Watch out: Heatbed screw head tolerence i3 MK3S
Posted by: @pru-117

Just a quick bit of feedback ... on assembling the heatbed, I noticed that not all of the screws went down properly into the recess - this appears to be a tolerencing issue.  For me, I dug into the spares bag, and found two screws there which were OK.  Just thought I'd make any assemblees aware.

Regards, Steve

 

 

Hello and welcome here in the Prusaforum!

It is probably not manufactured according to ISO 10642 or DIN 7991. The diameter of the head should be 6mm. I would just pick the best ones. Prusa supplies a bag of replacement screws.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 29/07/2020 8:44 pm
Share: