Notifications
Clear all

"Waiting for nozzle and bed cooling" but never cools  

  RSS
Chelsea the Librarian
(@chelsea-the-librarian)
New Member
"Waiting for nozzle and bed cooling" but never cools

Hello,

I bought my i3 printer about a month ago and I just finished assembly, but when I start the self-test this message appears: "Waiting for nozzle and bed cooling."  I tried restarting a few times, and I also tried leaving it for a while (over an hour), but the temperature only ever went down a few degrees.  I'm very new at this and would love some ideas as to what I can do to fix/adjust.  Thanks!

Posted : 16/04/2021 12:25 pm
Dan Rogers
(@dan-rogers)
Noble Member
RE: "Waiting for nozzle and bed cooling" but never cools

It probably means some things are not plugged in or plugged in correctly in the Einsy box.  I'd check all connections are in their proper place.

 

Posted : 16/04/2021 5:55 pm
Clarmrrsn
(@clarmrrsn)
Honorable Member
RE: "Waiting for nozzle and bed cooling" but never cools

Reseat and check connections fir both thermistors 

Sounds like a loose connection, or plugged in the wrong way round

Tank you very much!...
Posted : 16/04/2021 5:59 pm
Share: