Notifications
Clear all

Settings for filaments  

  RSS
Schehlein
(@schehlein)
Active Member
Settings for filaments

Hey everybody.

We just bought those two filaments from the prusa-shop:

PLA Extrafill Light Ivory 750g and PLA Extrafill Traffic Black 750g

We are using the Prusa Slicer (newest version) for slicing, but unfortunately we were not able to find a template for the filaments (I think, they are made by Filamentum). Do you have any advice wich settings we should use?

Thanks for your aid and best regards!

Sabine & Bernd

Posted : 31/05/2019 9:01 pm
Vojtěch
(@vojtech)
Honorable Member
RE: Settings for filaments

Start with the "Generic PLA" profile. It'll work just fine.

Posted : 31/05/2019 9:27 pm
Schehlein liked
Peter M
(@peter-m)
Noble Member
RE: Settings for filaments

As above and always check temps on the box.

Posted : 01/06/2019 4:57 pm
Share: