Rogues gallery of failed prints and reason for the failure?
 
Notifications
Clear all

Rogues gallery of failed prints and reason for the failure?  

  RSS
Jimbo
(@jimbo-4)
Active Member
Rogues gallery of failed prints and reason for the failure?

I have just completed the build of my Mk 3S+. A couple of evenings of "slow and steady" and I got it working first time....I'm well pleased. I'm now going to work on calibration and print quality before I try any "production" printing. What would be VERY helpful is a series of pictures of print examples so that a newby like me can benefit from the experience of others.....I would like to be able to compare my prints to pictures of prints with analysis of what went wrong with the prints that were photographed, so I could apply the right fix first time. That would save a lot of test prints and wasted filament. If I've  asked for something that already exists, mea culpa, but Google is my weapon of choice and it may have failed me this time.

Thanks Guys

Jim

Posted : 10/05/2021 8:27 pm
--
 --
(@)
Illustrious Member
RE: Rogues gallery of failed prints and reason for the failure?

Try the Prusa printing handbook that came with your printer. It has some good 'what not to do' examples. Plus, Prusa has hundreds of online guides that go into detail on many subjects. 

Posted : 10/05/2021 8:56 pm
Jimbo
(@jimbo-4)
Active Member
Topic starter answered:
RE: Rogues gallery of failed prints and reason for the failure?

Thanks Tim, and sorry for the late response. I've found the diagrams you wrote of, and have got a lot closer to an acceptable print. Thanks!

Posted : 16/05/2021 6:10 pm
ssill2
(@ssill2)
Prominent Member
RE: Rogues gallery of failed prints and reason for the failure?

I've also found this helpful

https://all3dp.com/1/common-3d-printing-problems-troubleshooting-3d-printer-issues/

Posted : 16/05/2021 6:18 pm
jsw
 jsw
(@jsw)
Noble Member
RE: Rogues gallery of failed prints and reason for the failure?

You can also check out the Blob Of Doom Gallery here ... 😉

https://www.flickr.com/groups/[email protected]/

 

Posted : 16/05/2021 10:45 pm
cwbullet
(@cwbullet)
Illustrious Member
RE: Rogues gallery of failed prints and reason for the failure?

Also, post in the Hall of Fame as a Hall of Shame.  

--------------------
Chuck H
3D Printer Review Blog...
Posted : 16/05/2021 11:48 pm
Share: