Notifications
Clear all

ripples on flat surface PLA  

  RSS
kabauter
(@kabauter)
New Member
ripples on flat surface PLA

Hi there,

just built my MK3S+ with my family. It was great fun and the printer is a huge step up from my Anycubic i3 mega S. One of my first prints shows strange ripples/waves on the flat surface of the print. They can be found in one corner of the print. Calibration was successful. 

In the affected corner the edge is somehow squished. I'm experiencing this on all prints at roughly that height.

What can I do?

Posted : 02/04/2021 9:34 pm
Peter M
(@peter-m)
Noble Member
RE: ripples on flat surface PLA

Warping, and at the top the filament has no room to go and nozzle gets to close to the model.

Is the first layer good?

Posted : 03/04/2021 4:58 am
Share: