Notifications
Clear all

Printing Issues  

  RSS
Mkauley
(@mkauley)
New Member
Printing Issues

I had an issue this morning where a model was badly sliced and caused plastic to pool up around the extruder nozzle. After clearing/cleaning everything up, I reran the calibration and got everything set up right.

I then tried to do a quick print of some spool parts and it wasn't going well. See the attached images.

I'm new to the hobby so still learning 🙂

Posted : 26/06/2021 2:03 am
Diem
 Diem
(@diem)
Illustrious Member
RE: Printing Issues

That looks like poor adhesion due to fingerprints on the plate.

Clean the sheet with dishwashing detergent (Dawn/Fairy) and plenty of HOT water, rinse well and dry with a fresh paper towel. Handle by the edges only.

Cheerio,

Posted : 26/06/2021 3:53 am
Share: