Notifications
Clear all

nylon guide assembly  

  RSS
gavin_the_newf
(@gavin_the_newf)
New Member
nylon guide assembly

Hey, any tips beyond the instructions very generic "insert and twist" on how to properly insert the nylon filament? Seems impossible to get it to actually stick/stay inside the extruder. No idea if there's an issue with the tip I cut, if it's not being inserted far enough, not twisting enough??

Thanks in advance.

Napsal : 10/09/2020 8:41 pm
Infiltrator
(@infiltrator)
Eminent Member
RE: nylon guide assembly

Anyone have an answer here?  I am having the exact same problem.

Napsal : 20/09/2020 2:12 pm
maxoid50
(@maxoid50)
New Member
RE: nylon guide assembly

Also having trouble. Any advice? I don't want to fuck it up my endlessly trying to jam it in.

I managed to find this guy doing it

At 10:40 but I'm still unsure of what he's doing or how it's working. I tried to mimick him exactly but it won't stick in.

 

Napsal : 24/09/2020 6:18 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: nylon guide assembly

@maxoid50

have you tried screwing an m3 screw into the hole?

if so, is it tight?

the print size might be too tight...   

It might be an idea to open the hole out a tiny bit... 

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Napsal : 25/09/2020 4:41 pm
Infiltrator se líbí
Infiltrator
(@infiltrator)
Eminent Member
RE: nylon guide assembly

@joantabb

For me, I ended up asking support and they basically just said push harder.  I put my whole body into it (120kgs) and had my wife holding the extruder - but we got it in.

Had I thought of it, I would have done what you suggested and tried to screw it out a bit with a screw or something.  It seems like the best solution.

Napsal : 26/09/2020 2:26 pm
Zoltan
(@zoltan)
Member Moderator
RE: nylon guide assembly
Posted by: @gavin_the_newf

Hey, any tips beyond the instructions very generic "insert and twist" on how to properly insert the nylon filament? Seems impossible to get it to actually stick/stay inside the extruder. No idea if there's an issue with the tip I cut, if it's not being inserted far enough, not twisting enough??

Thanks in advance.

Which chapter of the manual do you refer to?

even an old man can learn new things 🙂
Standard I3 mk3s, MMU2S, Prusa Enclosure, Fusion 360, PrusaSlicer, Windows 10
PRUSA MINI+ Prusalink + Prusa Connect

Napsal : 09/10/2020 6:43 am
Share: