Not much filament coming out of nozzle.
Very little filament coming out of nozzle, about the size of a human hair. How can I increase the amount? Thanks for any help.
RE: Not much filament coming out of nozzle.
The string laid out on the bed is and should be quite thin, about as thick as two writing papers (0.2 mm).
If it is much thinner than that, something is wrong.
Can you show us a picture of what it looks like.
Bear MK3 with Bondtech extruder
RE: Not much filament coming out of nozzle.
Very little filament coming out of nozzle, about the size of a human hair. How can I increase the amount? Thanks for any help.
Which filament and which nozzle do you use? Does this happen during the printing process or during manual feed?
Possibly the nozzle is blocked or dirty...
Pictures or a video would be very helpful.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Not much filament coming out of nozzle.
Very little filament coming out of nozzle, about the size of a human hair. How can I increase the amount? Thanks for any help.
If it was working previously, you may just nave a partial nozzle clog. Read up on doing cold pulls to clear it.