New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU
 
Notifications
Clear all

New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU  

  RSS
victorious416
(@victorious416)
Active Member
New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU

Hi guys, I'm almost done with my MK3S setup.  Just have a few wiring questions before i check if everything is connected properly and do a calibration test.

First question is, on the silver PSU there was a 0.4 power panic daughterboard with 3 soldered wires.  B&W wire (wired it to the Einsy Rambo no issues).  And the other soldered wire was a red one soldered to the 24v connection on the power panic, but I'm not sure what it's suppose to connect to, since the length is much shorter  than then B&W wires.  Here's a pic...

Second and 3rd question are sort of similar, so I'll ask it together.  For the LCD connectors (2) and the fan connectors (2), does it matter which slot they go into.  Will it fry the board or just give an error and let me know its connected wrong.  I accidentally started wiring everything up then when I got to these steps saw that my 2 fan connectors and 2 LCD connectors have similar connectors now I'm not sure which is which.  Is this crucial?  Or will both supply power correctly regardless?

 

Thanks

Best Answer by Dave Avery:

it connects to the 24V output of the supply ( screw terminal)

Posted : 10/08/2019 8:04 pm
--
 --
(@)
Illustrious Member
RE: New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU

Very bad idea to route the red wire over the top of the frame here:

Posted : 10/08/2019 9:20 pm
--
 --
(@)
Illustrious Member
RE: New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU

As for FAN and LCD wires,  have you read the assembly guide?  If not, you are in for some rather fun times.

Posted : 10/08/2019 9:21 pm
victorious416
(@victorious416)
Active Member
Topic starter answered:
RE: New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU
Posted by: Tim

Very bad idea to route the red wire over the top of the frame here:

 

 

Hi. It's not.  I'm asking where it goes......  It's not configured for anything yet....

Posted : 10/08/2019 9:28 pm
victorious416
(@victorious416)
Active Member
Topic starter answered:
RE: New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU
Posted by: Tim

As for FAN and LCD wires,  have you read the assembly guide?  If not, you are in for some rather fun times.

Definately.  Just wanted to hear how critical it was for the connectors in this case...

This post was modified 2 years ago by victorious416
Posted : 10/08/2019 9:29 pm
Dave Avery
(@dave-avery)
Honorable Member
RE: New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU

it connects to the 24V output of the supply ( screw terminal)

Posted : 10/08/2019 10:11 pm
victorious416
(@victorious416)
Active Member
Topic starter answered:
RE: New Member Here. Issue Wiring Power Panic 0.4 On Silver PSU
Posted by: david.a66

it connects to the 24V output of the supply ( screw terminal)

Awesome!  Thank you David 😉

Posted : 10/08/2019 10:18 pm
Share: