Notifications
Clear all

MK3 Carriage screws  

  RSS
nathan.w12
(@nathan-w12)
New Member
MK3 Carriage screws

Hi there

I've been running my mk3 for a while now without issue but having recently replaced the cooling fan I noticed that the bottom two screws for the carriage are now not biting and leaving a pretty bit gap.I honestly don't remember if there were nuts in that section when I assembled it or if I've stripped the printed section.

Before I completely disassemble the whole thing again, am I better of reprinting the carriage? Do I go for the mk3s version as that looks slightly different to the one I have (one screw instead of two)? Any advise?

Posted : 11/10/2020 7:07 am
Share: