Notifications
Clear all

Mesh Bed Leveling Problems  

  RSS
Newplay123
(@newplay123)
New Member
Mesh Bed Leveling Problems

Hello,
I'm desperate, I've been trying the leveling for days, the pressure is getting better, but now it prints on the right side so strange. See photos.

My values are :
Left: 14
Right: 2
Front: 14
Rear : 10

And Z stands at : -1.250

What can I do better ?

Posted : 17/04/2021 8:14 am
Diem
 Diem
(@diem)
Illustrious Member
RE: Mesh Bed Leveling Problems

You are close but a little bit too low, too squished. 

Your current value would probably print smaller objects OK but those with a very small base area and taller prints might fail.

Back off until those surface ripples *just* disappear and you will OK.

If you have not done so enable 7x7 mesh-bed levelling.

Cheerio,

Posted : 17/04/2021 5:16 pm
Share: