Notifications
Clear all

Loose extruder after step 14  

  RSS
connor.r.cunningham1994
(@connor-r-cunningham1994)
New Member
Loose extruder after step 14

all the parts are there im not missing the cover or anything but when i screw the m3x40's and make it flush with the bottom the extruder seems loose i can tighten it more but then the m3x40's would be sticking out 3mm or so. any suggestions?

Posted : 23/07/2020 4:35 pm
Walleye
(@walleye)
Eminent Member
RE: Loose extruder after step 14

Hi,

3mm stick out is a lot, are you sure you got the right length bolt?

Posted : 24/07/2020 5:32 pm
connor.r.cunningham1994
(@connor-r-cunningham1994)
New Member
Topic starter answered:
RE: Loose extruder after step 14

@dalee1002000

yeah it was the right one after all the only one bigger is very noticeably bigger. i ended up loosening it so it was flush, continued with the x-axis carriage steps and then once that was secure and i the guide mentioned to make sure there were no  more gaps i went back and tightened it up. Everything seems good now

Posted : 24/07/2020 5:52 pm
Share: