LCD Display Keeps Looping Back to Language Selection After Initial Assembly
 
Notifications
Clear all

LCD Display Keeps Looping Back to Language Selection After Initial Assembly  

  RSS
noldfrnd01
(@noldfrnd01)
Active Member
LCD Display Keeps Looping Back to Language Selection After Initial Assembly

I think I did everything right but something may have gone wrong.  When I turn the printer on for the first time it shows the language selection menu.  When I select English it shows the Prusa start up for a few second, then returns to language selection.  I was expecting to be able to select a self test at this point but it seems to just keep rebooting.  Any idea where to go from here?

Posted : 13/02/2020 11:04 pm
noldfrnd01
(@noldfrnd01)
Active Member
Topic starter answered:
RE: LCD Display Keeps Looping Back to Language Selection After Initial Assembly

Never mind  - I'm an idiot.  The accept button is pressing the turning switch.  I was pressing the X which of course was cancelling the language selection.  D'oh.

Posted : 13/02/2020 11:10 pm
rmm200
(@rmm200)
Noble Member
RE: LCD Display Keeps Looping Back to Language Selection After Initial Assembly

Thank you!

You proved my point, showing people make that mistake.

I will keep mentioning it as a possible cause of resets.

(Glad you figured it out - and happy printing!)

Posted : 14/02/2020 4:22 pm
Wasabi
(@wasabi)
New Member
RE: LCD Display Keeps Looping Back to Language Selection After Initial Assembly

Well, you can add me to that list. I was doing the same thing on initial startup!

Posted : 16/12/2020 1:06 am
Share: