Notifications
Clear all

Hotend / Nozzle? Problem with Filament  

  RSS
Anim
 Anim
(@anim)
Active Member
Hotend / Nozzle? Problem with Filament

Hello to the group, I have a problem with the Hotend/Nozzle? of my MK3 S... I have cleaned the nozzle, I have recalibrated the printer, it did not work. Filament are continuously sticking to the nozzle until at some point they drag on the printing plate and destroy the print. Does anyone have an idea? I print with Prusament PETG and a 0.4 nozzle.Slicer Prusa. Thanks a lot.

Posted : 03/12/2020 10:06 pm
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Hotend / Nozzle? Problem with Filament
Posted by: @anim

Hello to the group, I have a problem with the Hotend/Nozzle? of my MK3  S... I have cleaned the nozzle, I have recalibrated the printer, it did not work. Filament are continuously sticking to the nozzle until at some point they drag on the printing plate and destroy the print. Does anyone have an idea? I print with Prusament PETG and a 0.4 nozzle.Slicer Prusa. Thanks a lot.

Your first layer calibration may not fit. Take a look at these pages: https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-assembly-and-first-prints-troubleshooting/life-adjust-z-my-way/

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 03/12/2020 11:14 pm
Share: