Notifications
Clear all

Flow set to 95 as standard?  

  RSS
MileHigh3Der
(@milehigh3der)
Estimable Member
Flow set to 95 as standard?

When I have my Mk3S/MMU running and I look at the 'Tune' settings, the Flow = 95?  I didn't see this as an option in the Prusa Slicer?  If anything, I find underextrusion more an issue than over.  Where can I set this to 100-101?

Posted : 02/12/2019 6:31 pm
Neophyl
(@neophyl)
Famed Member
RE: Flow set to 95 as standard?

Its located in the custom gcode section - Printer Settings > Start gcode I think.

Posted : 02/12/2019 7:25 pm
Share: