First print with PLA
Can you please tell me what I'm doing wrong in the frog's print settings?
There are a lot of artifacts and stretching of the plastic lines when raising the stop Z.
Leaks underneath the front legs.
First layer 200.
Other layers 195.
Print setting 0.1 mm Detal.
Printer Prusa i3 MKS.
Lowered the temperature due to the large number of strings.
Increasing the retraction to 1.5 did not help.
Material: PRUSA PLA.
No terrible but could use some fine-tuning
What kind of fine-tuning would you do?