Notifications
Clear all
First post while buiding MK3.
So far so good on my 1st 3D printer build. Directions are better than most but it needs a 2.5mm ball driver vs the wrench. I had a "T" wrench that is better, but a driver would be great.
Question on the heating block though. Says the dot color should be yellow/orange, mine is yellow. If yellow or orange is OK I am fine.
Looking for support link but though I would try here first!
THX!!
Posted : 30/11/2019 9:10 pm
RE: First post while buiding MK3.
Yellow is ok 😉 , but I think I am already late, as you are already printing.
even an old man can learn new things 🙂
Standard I3 mk3s, MMU2S, Prusa Enclosure, Fusion 360, PrusaSlicer, Windows 10
PRUSA MINI+ Prusalink + Prusa Connect
Posted : 04/12/2019 1:16 pm