first post, sorry, but print bed wiring to short? Original Prusa i3 MK3S kit.
 

first post, sorry, but print bed wiring to short? Original Prusa i3 MK3S kit.  

  RSS
Grumpy
 mwb
(@mwb)
New Member

print bed wiring to short? the only thing that the Manuel doesn't show is the routing of the print bed wiring. no matter what way i rout it, its two dang short !!!!!. 7. Heatbed & PSU assembly (Black PSU) 27 to 33. there is no reference to routing it in >>>>>>>

Cable management (part 1) to the end!!!!! or Heatbed & PSU assembly (Black PSU) 27 to 33. HELP pleases.. I may be to hot and tired, may be i mist it, its only 103 today. can ant one post a picture of the proper way to rout the wires? 

Posted : 12/07/2020 2:50 am
Grumpy
 mwb
(@mwb)
New Member

 

LOL the heat must be getting to me today, looking the Prusa i3 Octoprint Raspberry Pi case, the heat bead goes to the Einsy board. LOL I will read the instructions again. sorry for this post!

Posted : 12/07/2020 3:10 am
Oxygen
(@oxygen)
Estimable Member

First post and you made it in the wrong section: this is the section about the Prusa Mini and not the Prusa i3 MK3s (sorry)

Mini with FW:4.1.0 + Bondtech Heatbreak...
Posted : 12/07/2020 9:29 am
joan.t
(@joantabb)
Veteran Member Moderator

Welcome to the forum, Mwb, 

I hope you have cooled down a little... 🙂

the Forum fairy moved your posts to the Mk3S section for you! 

regards, Joan...

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK...
Posted : 12/07/2020 1:27 pm
Share:

Please Login or Register