First layer problems  

  RSS
Wokipokei
(@wokipokei)
Active Member

The layer lines aren't touching the wall, I also don't know is my z is set too high.

Posted : 08/04/2020 7:30 pm
Neophyl
(@neophyl)
Noble Member

It’s hard to tell with that translucent filament. When you peel it off do the lines separate when you try to pull them apart ?  If so then it should go lower, it should be a sheet of plastic when removed. 

Posted : 08/04/2020 8:06 pm
peter.m26
(@peter-m26)
Reputable Member

Search in the forum for the movie someone made, with very good zoom in, and good and bad settings.

Posted : 08/04/2020 8:18 pm
Wokipokei
(@wokipokei)
Active Member

@neophyl

Yes, the layer lines do separate when pulled. 

Posted : 08/04/2020 8:29 pm
Wokipokei
(@wokipokei)
Active Member
Posted by: @peter-m26

Search in the forum for the movie someone made, with very good zoom in, and good and bad settings.

Do you have the link to it? I cant find it in this fourm.

Posted : 08/04/2020 8:31 pm
peter.m26
(@peter-m26)
Reputable Member
Share:

Please Login or Register