First layer
Trying to get the first layer right.
I thought it looked ok. I didn’t have a tool to measure it.
that square does have one straight side and one janky side.
Then I noticed a shift while making circles. There is a shift on the low left and upper right.
I just cancelled the print to focus on the shift. If I let it keep going, some of the gears end up connected
I double checked the xyz but it just reports ok.
Best Answer by WgnMn:
I might have solved this. I started going over the x/y movements very carefully and realized that the x axis motor gear was not completely tight.
This caused the small shift while moving diagonally.
RE: First layer
I might have solved this. I started going over the x/y movements very carefully and realized that the x axis motor gear was not completely tight.
This caused the small shift while moving diagonally.
RE: First layer
@wagenman
Thank you for information. The problem occurs frequently and is often discussed.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.