Notifications
Clear all

First Assembly Tips?  

  RSS
RayRay
(@rayray)
Active Member
First Assembly Tips?

I just ordered a MK3S and I'm looking for tips to be ready for assembly. Do I need to buy grease for the bearings, or is it included? If I need to buy grease, what is the recommended/best product? 

I already have a Maker Select Plus, so I have supplies like glue sticks, IPA etc... Aside from extra V6 nozzles, are there any other items I should buy?

Looking forward to any advice you guys might have!

Posted : 10/04/2020 6:18 pm
Lichtjaeger
(@lichtjaeger)
Noble Member
RE: First Assembly Tips?

There is an article about greasing the bearings on Prusacommunity.

Rods and bearings do have an initial greasing, but it is better to clean and regrease them.

Posted : 10/04/2020 7:16 pm
RayRay liked
Pedroid
(@pedroid)
Trusted Member
RE: First Assembly Tips?

Don't use the printed manual, but the online version and read the comments.

Posted : 11/04/2020 9:33 am
Share: