Notifications
Clear all

Finished assembly feedback...  

  RSS
pbreed
(@pbreed)
New Member
Finished assembly feedback...

1)Got the Y axis backwards.
Had to disassemble and fix when heatbed would not mount.
So a more  specific warning that Y axis has a left/right would be helpful.

 

2)Wireing,It would be way easier to do final wiring if the door /electronics opened to the outside, rather than the inside of the printer.
IE turn the electronics mount/door around 180 degrees so one had clean access from the outside.

3)The warning about breaking the magnet needs to be larger and in big print, thank you for providing a spare set of magnets.

Very nice manual, very clear instructions, I enjoyed building the printer.

 

 

 

 

 

 

 

 

 

Posted : 07/02/2021 11:16 pm
cwbullet
(@cwbullet)
Member
RE: Finished assembly feedback...

You should send this by email to Prusa.  I am sure they do not get a lot of positive feedback.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 08/02/2021 10:35 am
Share: