Notifications
Clear all
Feedback on first prints?
Hello everyone, I just finished assembling my printer and doing my first calibration, I'm not 100% sure I did the vertical calibration correctly so I wanted some feedback from the forum.
https://photos.app.goo.gl/BcrtYKHd7p3G5Gc3A
The gecko is just this one from thingiverse loaded in prusa slicer and rotated 90 with no modification of the default settings.
Posted : 21/09/2020 4:46 am
RE: Feedback on first prints?
Good job. Not bad for the first couple. You have dialed it it in pretty good.
--------------------
Chuck H
3D Printer Review Blog
Posted : 26/09/2020 12:50 pm