Notifications
Clear all

Feedback Needed - New User Printer Setup  

  RSS
kiril
(@kiril)
New Member
Feedback Needed - New User Printer Setup

Hello,

I am new to 3D printing and just got my MK3S kit (love assembling things). Would deeply appreciate if I can get some feedback from an experienced user (pictures attached) how bad (or good) my assembly and settings are. Printed the 3D Benchy and get the feeling it could be better, but don't know what to adjust. My X belt value is 164, so this is one area for improvement (for some reason cannot adjust through the screws near the motor and probably have to disassemble the extruder). 

Thanks! 

 

This topic was modified 4 years ago 3 times by kiril
Posted : 26/08/2020 5:00 pm
Share: