Notifications
Clear all

Extruder crashing into print bed at beginning of print  

  RSS
sahart2
(@sahart2)
New Member
Extruder crashing into print bed at beginning of print

I calibrated the print bed using calibration reset, then XYZ calibration, and then first layer calibration. Both of those seemed to work well, the extruder nozzle DIDNT crash into to print bed.

Then I went to start an actual print and at the very beginning when the nozzle goes to the nine points to calibrate, it started pressing down too far and hitting the print bed...

 

any ideas?

This topic was modified 2 years ago by sahart2
Posted : 29/04/2020 1:32 am
Share: