Notifications
Clear all

Calibration -> First layer cal doesn't work  

  RSS
Sébastien
(@sebastien-5)
New Member
Calibration -> First layer cal doesn't work

I just finished the mounting of my new i3 MK3S+ . I've made all claibration but the first layer calibration doesn't work. The head move on the bed drawing the first layer but not filament is going out from the nozzle. What's wrong ?

Posted : 27/11/2021 8:35 pm
BogdanH
(@bogdanh)
Honorable Member
RE: Calibration -> First layer cal doesn't work

Does the filament come out of nozzle when you load the filament?

[Mini+] [MK3S+BEAR]

Posted : 27/11/2021 8:46 pm
Sébastien
(@sebastien-5)
New Member
Topic starter answered:
RE:

Answer from the support : the sensor wasn't pluged at the right place on the motherboard. It should be connected on the second row 😀

 

 

This post was modified 2 years ago by Sébastien
Posted : 27/11/2021 9:49 pm
Share: