After MK3S MMU2S ugrade - fails to load filament at extruder
 
Notifications
Clear all

After MK3S MMU2S ugrade - fails to load filament at extruder  

  RSS
Jerry Siegel
(@jerry-siegel)
Active Member
After MK3S MMU2S ugrade - fails to load filament at extruder

Filament will not load at the extruder. It gets jammed... either at the bondtec gears or at the transition from PTFE tube to the heat break. Everything worked fine before this upgrade. Also updated to the lastest firmware, no joy. Any ideas on how to fix this?

...
Posted : 26/03/2019 9:14 pm
Franz
(@franz-2)
Active Member
Re: After MK3S MMU2S ugrade - fails to load filament at extruder

Same here

Posted : 16/04/2019 4:29 am
Share: