Notifications
Clear all

Y axis sensor not working. Again.  

  RSS
ryan.f15
(@ryan-f15)
Estimable Member
Y axis sensor not working. Again.

I am getting really sick of this.  I've updated firmware, reloaded everything, redone wires, etc.  The extruder smacks into the side of the printer when it's calibrating.  I've followed instructions TO THE LETTER and this repeatedly happens.  Is there a fix for this permanently so that the extruder stops doing this?  Several of my friends that have these locally have run into the exact same issue.

Posted : 05/11/2019 2:23 am
Dave Avery
(@dave-avery)
Honorable Member
RE: Y axis sensor not working. Again.

on the mk2 it's either a bad wire or switch or the bed not hitting the switch

Posted : 05/11/2019 4:36 pm
ryan.f15
(@ryan-f15)
Estimable Member
Topic starter answered:
RE: Y axis sensor not working. Again.

@david-a66

It's  the line right by the switch that pushes out and stops it from hitting the switch.  You'd think prusa would have fixed this by now.

Posted : 08/11/2019 11:02 pm
Share: