Notifications
Clear all

I start the print but nothing moves  

  RSS
justin.w4
(@justin-w4)
New Member
I start the print but nothing moves

every once and a while I start to print on my mk2.5 and it preheats to the set temperature does the bed level calibration then moves the head to the beginning wipe area and doesn't move after that. however, the print percentage increases rapidly. I have an original Prusa i3 mk2.5 no modifications and in my closet with a heater acting a makeshift enclosure for abs

Posted : 23/12/2018 9:53 pm
agfgarcia
(@agfgarcia)
New Member
Re: I start the print but nothing moves

Did you ever find a solution for this? I'm experiencing the same issue on an original Prusa i3 mk3 no modifications, without an enclosure.

Posted : 23/01/2019 5:31 pm
Share: