Notifications
Clear all

XYZ calibration fault on last point  

  RSS
Jaroslav Trnka
(@jaroslav-trnka)
New Member
XYZ calibration fault on last point

Hi, after  upgrading firmware to 3.9.3-3556 I am not possible to go throu XYZ calibration. After the  fourth point it stops with error message saing to read the manual. I have MK2.5S. What now, downgrade?

Posted : 26/01/2021 8:23 am
Jaroslav Trnka
(@jaroslav-trnka)
New Member
Topic starter answered:
RE: XYZ calibration fault on last point

After dowgrade to 3.9.2 it works again.

Posted : 26/01/2021 10:18 am
Michael
(@michael-11)
New Member
RE: XYZ calibration fault on last point

Same....using PindaV2, superpinda is off 

Fail at Point 3 or 4

Posted : 07/02/2021 1:25 pm
TOOCH
(@tooch)
Active Member
RE: XYZ calibration fault on last point

Same issue here. Maybe I need to downgrade too...

Double checked everything, auto=home is perfect, everything is square and all points reachable manually with perfect parallel height.

Posted : 17/04/2021 6:56 pm
Share: