XYZ calibration fault on last point  

  RSS
Jaroslav Trnka
(@jaroslav-trnka)
New Member

Hi, after  upgrading firmware to 3.9.3-3556 I am not possible to go throu XYZ calibration. After the  fourth point it stops with error message saing to read the manual. I have MK2.5S. What now, downgrade?

...
Posted : 26/01/2021 8:23 am
Jaroslav Trnka
(@jaroslav-trnka)
New Member

After dowgrade to 3.9.2 it works again.

...
Posted : 26/01/2021 10:18 am
Michael
(@michael-11)
New Member

Same....using PindaV2, superpinda is off 

Fail at Point 3 or 4

Posted : 07/02/2021 1:25 pm
TOOCH
(@tooch)
Active Member

Same issue here. Maybe I need to downgrade too...

Double checked everything, auto=home is perfect, everything is square and all points reachable manually with perfect parallel height.

Posted : 17/04/2021 7:56 pm
Share:

Please Login or Register