first Layer on Supports
Hi
Just wondering if there is a solution for this
When I print and using supports for, the first layer printed on the support structure always looks a kind of "stringy" like in the picture
When I do bigger structures on supported areas, the 1 layer often has loose strings and does not look that good connected to the next layer
Is there any solution to this?
BW
Sascha
RE: first Layer on Supports
I think that is normal - the only way to avoid this is to have a look at the orientation of the part. If you take a look to the knob in your photo I would print it so that the surface facing the person pushing or rotating the knob is not printed on supports.
Best regards, Clemens
Mini, i3 MK2.5S, i3 MK4, CClone (Eigenbau)
RE: first Layer on Supports
I seem to remember reading somewhere that Cura handles that a little better. YMMV