I was getting MinTemp errors and found burned wires on the heat bed power wires. Plastic is melted where the connection is made on the circuit board. Has anyone just gotten a specific replacement part such as this and soldiered it yourself?
Posted : 10/12/2020 4:08 pm
hey @grandpa-joe,
I had this problem 2 times in about 3 weeks probably because the strain relief of my heatbed-cable wasn't done proper by me. After this, I soldered the wires directly to the mainboard and since then, I never had any issues. (and I 've made the strain relief correctly)
Posted : 13/01/2021 6:48 pm
Thanks. I ended up with a new circuit board and a new heat bed.
Posted : 14/01/2021 1:58 am
Just be careful and try to avoid what caused it. This could result in a fire. I burned up one controller board.
Posted : 14/01/2021 2:13 am
Primermecos liked